Four service areas, built on measurement.
Where does your plant’s water come from, where does it go, and what is carried in it? For solid waste, we ask the same question in tonnes and in cost. Our service areas treat these cycles together and turn the measured data into an investment case. Our recommendation follows the measured data, not a supplier.
01 Water treatment
The quality of water going into a process and the load leaving the plant are tied together. We start by measuring what is actually there.
Process water and effluent characterisation
Performance review of the existing treatment line
Feasibility and prioritisation for water reuse
Flow, load and mass balance studies
Equipment and supplier specification support
02 Solid waste and valorisation
Splitting waste by type changes both the disposal cost and the recovery routes open to you.
Waste inventory and separation by type
Sludge management and reduction options
Review of recovery and valorisation routes
Disposal cost and logistics analysis
Prioritisation against the waste hierarchy
03 Sustainability and compliance advisory
Buyer expectations have to be matched against data your plant can actually measure and stand behind.
Setting up an environmental data routine
Gap analysis between current practice and reporting requirements
Defining water, waste and energy indicators
Improvement roadmap and sequencing
Preparation for buyer audits and information requests
04 Investment and funding support
We help facilities build a sound investment case from measured data, compare options on cost and outcome, and identify suitable funding and financing routes, such as grants, incentives and green finance, supporting the application process.
Investment case built from measured data
Option comparison on cost and outcome
Identification of suitable funding and financing routes (grants, incentives, green finance)
Support with the application process
For investors and funders: We help investors and funders assess textile water and waste projects against an independent, measured baseline.
An independent decision file your board, or your investors, can review against measured data.
Suppliers and partners
We select the most suitable technology partner from international companies, and source the CapEx equipment from the local supply chain wherever possible, integrating it into one working solution. Our recommendation follows the measured data, not a supplier.
One plan, one point of responsibility: technology partners, laboratories and your plant team work to a single plan, and we write the specification on your behalf, so you are never tied to one supplier.
In practice
Uvoria is currently working with a textile-sector client on water treatment, sludge and waste challenges typical of textile plants.